Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA11] Extension cable for Axiom 9 to CTP-s
06-03-19, 02:35 PM (This post was last modified: 06-03-19 02:43 PM by Chuck - Raymarine - Moderator.)
Post: #2
RE: [CA11] Extension cable for Axiom 9 to CTP-s
Welcome to the Raymarine Forum Rob,

Unlike the Axiom RV 9, the Axiom 9 MFD does not feature internal fishfinder circuitry and as such, cannot be directly mated to a fishfinder transducer. If considering use of a CPT-S transducer, then the Axiom 9 MFD should be interfaced to a CP100 DownVision Sounder Module, which in turn would be interfaced to the MFD or HS5 RayNet Network Switch via an appropriate length of RayNet (F) to RayNet (F) Cable.

DownVision, CPT-S, SideVision, and RealVision transducers are neither designed for nor supported for use as in hull transducers due to the relatively low power output of these transducers. If seeking an in-hull transducer for simply determining the numerical depth of the water depth beneath the transducer, then you may want to consider installation of the T70278 P79 Smart Transducer which in turn would be interfaced to the system's powered and properly terminated SeaTalkng / NMEA 2000 backbone. If seeking fishfinding capabilities, then the CPT-S transducer would be a good choice for sailboats, but it would be necessary to install it as a thru-hull transducer.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [CA11] Extension cable for Axiom 9 to CTP-s - Chuck - Raymarine - Moderator - 06-03-19 02:35 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)