Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA11] 3D contours
10-31-19, 11:37 AM (This post was last modified: 11-07-19 01:21 PM by Chuck - Raymarine - Moderator.)
Post: #1
[CA11] 3D contours
I have an A128 and Navionics says it is compatible with their Hot Maps Platinum chart. I'm trying to pull up the 3d shading available for the Georgia coast. I can't figure it out. I have the latest software download, 19.03 and updated the card yesterday. Any suggestions would be appreciated.
Find all posts by this user
Quote this message in a reply
11-07-19, 01:38 PM (This post was last modified: 11-07-19 01:40 PM by Chuck - Raymarine - Moderator.)
Post: #2
RE: [CA11] 3D contours
Welcome to the Raymarine Forum Bad Bait Bill,

A good video on this subject of Navionics Platinum Plus cartography use with a MFD running LightHouse II software may be found here. As indicated within the referenced video, ensure that the Chart View (MENU->PRESENTATION->VIEW & MOTION->CHART VIEW) has been configured to 3D and that 2D Shading (MENU->PRESENTATION->OVERLAYS->2D SHADING) has been configured to ON. 3D Exageration (MENU->PRESENTATION->VIEW & MOTION->3D EXAGERATION) may be adjusted to suit one's needs. Naturally, this feature will have greatest effect within areas having significant bottom slope (steep contour).
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)