[LW] [LW11] adjust rudder stop angle

[[email protected]]

Hi !

I have just started uo my EV 200 linear system. It seems to be working fine but only tried it in calm conditions.

My rudder stops are a bit to weak for the drive- they bend slightly during the dock side calibration, is it possible to enter the rudder stop angle manually to decrease it a few degrees in order to make it stop sooner? I have a working rudder position sensor, EV-1 ACU 200, Linear drive type 1.

Best Regards

Peter

[Louise - Raymarine - Moderator]

Dear Peter,

You need to set the rudder limits up on the EV200. You can find the instructions here.

Many Thanks
Louise

[[email protected]]

Thank you, it went quite easy with your support. You might have linked to a different doc. than the applicable one but i found in the Swedish version.

Best Regards and thanks for the support.

Peter

[Louise - Raymarine - Moderator]

You are welcome.