[CA] [CA11] eS128 running LH3 barometric/fishing maps stutters
|
11-13-18, 12:10 PM
(This post was last modified: 11-13-18 01:55 PM by Chuck - Raymarine - Moderator.)
Post: #1
|
|||
|
|||
[CA11] eS128 running LH3 barometric/fishing maps stutters
I am running LH3 v3.70.7 with a Navionics 960+ card on the eS128.
All seems fine, except for when activating the barometric/fishing detailed maps. It takes 2-3+ minutes to load the chart and often times only portions of the chart load. I do have a lot of sonar chart live tracks that were created on an older e125 Series (prior to the eS128) on this same Navionics card that I am now using for the eS128 and it also have a good amount of lsd-cache on it. I used to run LH2 on the e125 with a side by side barometric and detailed Navionics+ without performance issues (map load probably took 10-20seconds). Before trying things out with all user data removed from the Navionics card (again: I have quite a bit of sonarchart-live data on the card), I wonder if there is a known issue running barometric/fishing charts with LH3 on the eS128. |
|||
11-13-18, 01:59 PM
Post: #2
|
|||
|
|||
RE: [CA11] eS128 running LH3 barometric/fishing maps stutters
Welcome to the Raymarine Forum Pkjv,
We haven't received any similar reports of such issues which were related to the LightHouse 3 software. Most such cartography performance issues are traced back to a problem with the chart card, its contents, or with the MFD's memory card reader. When the SonarChart Live feature is configured OFF, is the same performance issue observed? |
|||
11-13-18, 03:09 PM
(This post was last modified: 11-13-18 03:46 PM by Chuck - Raymarine - Moderator.)
Post: #3
|
|||
|
|||
RE: [CA11] eS128 running LH3 barometric/fishing maps stutters
Hi Chuck
Thanks for your response. I will try out the other memory card slot and will also try out SonarChart Live configured off. I will report back next week. |
|||
11-13-18, 03:46 PM
Post: #4
|
|||
|
|||
RE: [CA11] eS128 running LH3 barometric/fishing maps stutters
You're welcome.
|
|||
11-20-18, 05:03 PM
(This post was last modified: 11-21-18 10:28 AM by Chuck - Raymarine - Moderator.)
Post: #5
|
|||
|
|||
RE: [CA11] eS128 running LH3 barometric/fishing maps stutters
Hi Chuck
Reporting back on the recommendation to run with SonarChart Live configured off. That did not make a change, however when I turned of sonar login altogether the performance issues disappeared. I also connected with Navionics and they recommended removing the combined old e125/eS128 and remove files from the trash can (using a MacBook). Removing the files by itself did not resolve the issue, but once I also removed it and also the trash can files things worked just fine. Hope this message might help others. Pat |
|||
11-21-18, 10:28 AM
Post: #6
|
|||
|
|||
RE: [CA11] eS128 running LH3 barometric/fishing maps stutters
Thanks for the follow-up comments.
|
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 1 Guest(s)