Raymarine forum / Raymarine Forums / Multifunction Displays v / [CA] [CA11] Lighthouse 3.9 - Waypoint Arrival Radius

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Lighthouse 3.9 - Waypoint Arrival Radius
05-28-19, 04:36 PM (This post was last modified: 06-03-19 04:12 PM by Chuck - Raymarine - Moderator.)
Post: #1
BobMack Offline
Junior Member
**
 		Posts: 5
Joined: Jul 2017
Reputation: 0
[CA11] Lighthouse 3.9 - Waypoint Arrival Radius
Looking in manual for procedures for adjusting the Waypoint Arrival Radius.

I past software this allowed a route to maintain a reduced radius then implementing a turn during a route. I have not adjusted my new lighthouse 3.9 and some turns end up starting way too soon when working within narrow channels.
Find all posts by this user
Quote this message in a reply
06-03-19, 04:15 PM (This post was last modified: 06-03-19 04:16 PM by Chuck - Raymarine - Moderator.)
Post: #2
Chuck - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 14,319
Joined: Oct 2014
Reputation: 43
RE: [CA11] Lighthouse 3.9 - Waypoint Arrival Radius
Welcome to the Raymarine Forum Bob,

Waypoint arrival has always been associated within an alarm within Raymarine systems. The waypoint arrival radius is configured within the LightHouse 3 Alarms settings (HOME->ALARMS->SETTINGS->ARRIVAL RADIUS).
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 3 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication