[CA] [CA11] Configure New Network and Incorporate S2 Course Computer

[ventus]

Ok, new diagram attached.

I left the VHF connection how I had it like you recommended.

I have been assuming that the Axiom 9 is indeed compatible with the RMK-10, is this correct? Just confirming.

For the RMK-10, I added the HS5 in the Nav Station and connected both Axiom displays to it as well as RMK-10. I will just run power wire for the RMK-10 instead of doing the FLIR POE. It is a 30' long (60' there and back run), according to the West Marine article, I should use 10/2 AWG for a 5 amp run of that length....I know the RMK-10 does not draw 5 amps...thoughts on gauge wire? I also have it running though a 1 amp fuse since I think that is the smallest....good there?

I saw that a Raynet to Raynet cable came in the box for the RMK-10, can I just use that in place of the A80161 I currently have on my diagram for the Axiom 7 to HS5 connection? I wasn't sure if it was a different type of Raynet cable in the box for the RMK-10.

For the HS5 I have it running through a 1 amp fuse as well with 18/2 since it is a very short run to power. Good there?

Also, I suppose the RMK-10 and HS5 also need drain wires sent to the Yanmar? Is it ok to connect multiple 14 AWG drain wires together at the nav station and also the helm, then run (1) 14 AWG wire from the bundle down to the Yanmar or does each unit requiring a drain wire need to be separate?

I think I might actually be good to go after this round. :-) I very much appreciate all of your wonderful help with this!