The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Autopilots v / [LW] [LW11] "No pilot" alarm on Raymarine ST6002 display

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[LW] [LW11] "No pilot" alarm on Raymarine ST6002 display
12-17-18, 04:02 AM (This post was last modified: 12-17-18 11:46 AM by Louise - Raymarine - Moderator.)
Post: #1
BLGPHIL Offline
Junior Member
**
 		Posts: 1
Joined: Dec 2018
Reputation: 0
[LW11] "No pilot" alarm on Raymarine ST6002 display
Hello,
After disassembling the instruments for more than a week to move them I alarm "No pilot" on the ST6002 control unit. In addition, I can not enter the "Dealer CAL" menu to reset the driver settings (the "CAL?" Screen does not appear after pressing "Auto" and the "-1" keys and +1) do not allow entering the menu modifying the parameters of the "Dealer CAL" menu.
Here is the installation:
- ST6002 control unit (pilot display)
- SmartPilot S2 Calculator
- Power unit: linear electric motor type 1
- Rubber sensor
- Fluxgate Compass.
- ST60 Tridata and wind mode
Thank you for telling me why I can not get into the "Dealer CAL" menu?
Sorry for my poor English…
cordially.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[LW11] "No pilot" alarm on Raymarine ST6002 display - BLGPHIL - 12-17-18 04:02 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication