Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Ferrite Supression required for new ACU-200?
12-10-16, 12:13 PM
Post: #1
Ferrite Supression required for new ACU-200?
I'm upgrading my A/H from a Raymarine 150/400 to the Evolution 1 with the ACU-200. I notice there is a Ferrite Supression module on the power line? Do I need this for my new unit? Any harm in leaving it there?

Thanks
Find all posts by this user
Quote this message in a reply
12-13-16, 02:01 PM (This post was last modified: 12-13-16 04:37 PM by Chuck - Raymarine - Moderator.)
Post: #2
RE: Ferrite Supression required for new ACU-200?
Suppression ferrites
Raymarine cables may be fitted with suppression ferrites. These are important for correct EMC performance. Should a ferrite be removed, then the RF emissions produced by the product may cause RF interference with other products (ex. VHF radios, stereo receivers, etc.). If a ferrite has to be removed for any purpose (e.g. installation or maintenance), it must be replaced in the original position before the product is used.

Should a ferrite not be packaged with the product, then it should not be necessary to install a ferrite on the cable which will be powering the product.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)