Threaded Mode | Linear Mode

Johnjohnjohn · 04-11-16, 11:29 AM

I have an i50 tridata that is replacing an st60 tridata. I have used the seatalk ng to seatalk connector cable to connect it to the remaining st60 and it appears to work OK. There is a remaining seatalk ng connector on the i50 which is not in use. Does that need the supplied terminator, or is OK just left unused? Thanks.

***Steve - Raymarine - Moderator*** · 04-11-16, 03:12 PM

That Seatalk NG port is if you connected via Seatalk NG interface to daisy chain with a spur cable (up to two). You are using the Seatalk 1 communication. The connector should be left unused.

Johnjohnjohn · 04-11-16, 03:26 PM

(04-11-16 03:12 PM)Steve - Raymarine - Moderator Wrote: That Seatalk NG port is if you connected via Seatalk NG interface to daisy chain with a spur cable (up to two). You are using the Seatalk 1 communication. The connector should be left unused.

That's great, thanks for the quick response. John

***Steve - Raymarine - Moderator*** · 04-12-16, 09:09 AM

Anytime, contact us with any future questions.